FERREX
Anticorrosive paint
- Corrosion protective
- Special adhesion
- Solvent-borne
FERREX is an activated multipigment anticorrosive paint. Finish: matt. Anticorrosive paint and adhesion primer for steel surfaces and aluminium outdoors and indoors. The adhesion of FERREX on zinc-coated (galvanized) surfaces as well as on prefabrication primers is also good.
The pigmentation of FERREX effectively prevents underfilm corrosion. FERREX can be overcoated with Teknos solvent-borne outdoor and furniture paints as well as with water-borne indoor paints. FERREX has good weather resistance and it can also be left without a top coat.
Technical data sheet
Safety data sheet
Surface preparation
Surfaces to be painted are cleaned from dirt, grease, oil and other impurities. RENSA STEEL washing agent, solvent wiping etc. is used for cleaning. Rust and corrosion are removed from the surfaces using scraping, wire-brushing, sanding, blast-cleaning or other suitable method. Old, glossy surfaces are roughened using sanding, blast-cleaning or other suitable method. Loose and poorly adherent old paint or coating is removed. Aluminium surfaces are roughened using sanding, blast-cleaning ot other suitable method.
Application
Before use stir the paint thoroughly. Apply by brush or spray. Recommended nozzle size for airless spray is 0.011 - 0.015''. Solvent-borne outdoor paints, e.g. WINTOL oil paint.
Furniture paints: paints from FUTURA series. Water-borne interior paints, e.g. paints from EKORA, TEKNOSPRO and TIMANTTI series. Solvent-borne interior paints, e.g. TEKNOFLOOR floor paint.
Application conditions
The surface to be painted must be dry. It is not recommended to paint surfaces that are above +50°C. During the application and drying period the temperature of the ambient air, the surface and the paint shall be above +5°C and the relative air humidity below 80%.
| Solids | abt. 43 % by volume |
|---|---|
| Volatile organic compound (VOC) | EU VOC limit value (kat A/i): 500 g/l. The product's VOC: max. 500 g/l. |
| Gloss | Matt |
| Density | abt. 1.25 g/ml |
| Practical spreading rate | 8 - 10 m²/l depending on application technique, substrate and the quality of surface. |
| Recommended film thickness | Dry film (µm) 40. Wet film (µm) 93. Theoretical spreading rate (m²/l) 10.8. |
| Drying time – touch dry | after 3 hours |
| Thinner | TEKNOSOLV 1639 |
| Clean up | TEKNOSOLV 1639 |
| Packages | 0,33 L, 1 L, 3 L, 10 L |
| Safety markings | See Safety Data Sheet. |