Solvent Free Antistatic Epoxy Coating

  • Chemical resistant
  • Conductive (ESD)
  • Corrosion protective
  • 2-component
  • Solvent-borne
  • DTM (direct-to-metal)
  • Primer

INERTA 268 is a solvent free epoxy-based antistatic coating.

The coating is used for insides of steel tanks and pipelines that are used for storing flammable liquids, also in explosion danger zone. Used for inside surfaces of tanks and pipelines for liquids and loose products, which form with air explosive mixtures. For laminate constructions and any other non-conducting surfaces for antistatic finish.

INERTA 268 contains antielectrostatic pigments. Coatings surface resistivity ρS is <107W and leakage resistance RU is <106W. The coating meets the requirements of protection against static electricity according to: PN-E-05204:1994 p.2.1 d) and PN-E-05203 p.2.4.1, 2.4.2, 2.4.15. The coating fulfills the requirements of TRbF 401 standard. Coating with outstanding adhesion to steel, laminates and mineral surfaces. Coating resistant to water, diesel oil, petroleum, unleaded petrol, biofuel, aviation fuel, fatty acid methyl esters, isooctane, toluene and xylene.

Solids abt. 99 % by volume
Total mass of solids abt. 1500 g/l
Volatile organic compound (VOC) abt. 15 g/l
Pot life 30 min (+23 °C)
Mixing ratio 2,5:1 by volume (comp. A : comp. B)
Hardener Comp. B: INERTA 268 HARDENER
Drying time – dust free after 6 h
Drying time – touch dry after 9 h
Drying time – fully cured after 7 days
Thinner Not recommended, if needed use TEKNOSOLV 564
Clean up TEKNOSOLV 025, TEKNOSOLV 564. Tools must be cleaned directly after use. Hardened material can be removed with use of mechanical treatment only.