TEKNOPOX FILLER 2112
Epoxy stopper
TEKNOPOX FILLER 2112 is a two-pack, nearly solvent-free epoxy stopper based on epoxy resin. The product belongs to a coating system whose reaction to fire has been tested according to the standard EN 45545-2.
For stopping up primed or blast-cleaned steel and aluminium plate surfaces, especially on large steel surfaces. Also suitable for concrete surfaces as a stopper and to fill the pores. The stopper is easy to work with and its adhesion to roughened steel surface or to a surface primed with epoxy coating is very good. The stopper cures fast and it can be sanded down the same day. The tested coating system comes up to the requirements for Requirement set R7 Hazard level HL1/HL2 by EN 45545-2.
Surface preparation
STEEL SURFACES: After general cleaning the steel surfaces are blast-cleaned to preparation grade Sa 2½.
PRIMED SURFACES: Paint coats older than 2 days are to be roughened before filling.
ALUMINIUM SURFACES: Treat the surfaces with RENSA STEEL washing agent. Surfaces are also roughened up with sweep blast-cleaning (AlSaS).
CONCRETE SURFACES: The concrete must be at least 4 weeks old, well-hardened and solid. Remove brittle concrete by grinding or hydro-blasting with sand.
Application
MIXING OF THE COMPONENTS: Mix the hardener with the base immediately before use either manually or by a slow-rotating drilling machine. Inadequate stirring or incorrect mixing ratio results in imperfect curing and impaired film properties.
If only part of the can is used for the paint mixture, the whole contents must first be mixed thoroughly.
The filler is applied by a filling knife. The knife marks and splashes are scraped off as soon as the filler has set.
Application conditions
The surface to be treated must be dry. During the application and drying period the temperature of the ambient air, the surface and the product shall be above +10°C and the relative air humidity below 80%. Additionally, the temperature of the surface to be treated and the product must be at least +3°C above the dew point of the ambient air.
Storage
The storage stability is shown on the label. Store in a cool place and in tightly closed containers.
Mix the hardener with the base immediately before use either manually or by a slow-rotating drilling machine.
| Total mass of solids | abt. 980 g/l |
|---|---|
| Volatile organic compound (VOC) | abt. 60 g/l |
| Pot life | 60 min (+23 °C) |
| Mixing ratio | 1:1 by volume (comp. A : comp. B) |
| Hardener | Comp. B: TEKNOPOX HARDENER 7217 |
| Drying time – dust free | 1.5 h (ISO 9117-3:2010) |
| Drying time – touch dry | 2.5 h (ISO 9117-5:2012) |
| Drying time – fit for sanding | after 4 h |
| Drying time – fully cured | 4 d |
| Clean up | TEKNOSOLV 9506 or TEKNOSOLV 6060. |
| Colours | Light grey. |
| Safety markings | See safety data sheet. |
| Approvals & certificates | EN 45545-2 |