TEKNOL JRM
Paint for edges
- Sealer
- Sealer
TEKNOL JRM is a water-borne acrylate paint.
Intended for coating edges of film-coated plywood and chipboard. Also for protecting the wood ends. TEKNOL JRM paint for edges is very flexible and its water permeability is low. The weather resistance is good. Before using the product, the manufacturer should be contacted to check the suitability of the product for the object in question.
Technical data sheet
Surface preparation
The surface must be clean and dry. The moisture content of the wood is to be below 20%.
Application
Stir thoroughly before use.
Apply the paint in 2 or 3 coats. Each coat must be allowed to dry before a new coat is applied.
Application conditions
During the application and drying period the temperature of the ambient air, the surface and the product shall be above +5°C and the relative air humidity below 80%.
Storage
Must not freeze. The best storage temperature is +10°C - +25°C.
| Solids | abt. 43 % by volume |
|---|---|
| Total mass of solids | abt. 650 g/l |
| Volatile organic compound (VOC) | abt. 0 g/l |
| Gloss | Semi-matt |
| Tinting system | Teknomix |
| Practical spreading rate | The values depend on the application technique, surface conditions, overspray, etc. |
| Drying time – dust free | 1 h |
| Drying time – touch dry | 1 h 20 min |
| Drying time - overcoatable | 2 h |
| Thinner | Water. |
| Clean up | Water. |
| Colours | Base 1 and base 3 (white and opaque colours). Other colours by agreement. |
| Safety markings | See safety data sheet. |