SILORA LW

Light wet room filler

  • Water-borne

Ready-to-use, water-borne light filler for wet areas.

Used for filling of joints and overall skimming of walls and ceilings in wet interior areas. The substrate can be gypsum, fibre board, concrete, lightweight concrete, plaster etc. Also suitable for filling of board joints.

SILORA LW has good adhesion and filling capability. The filler contains a long-acting agent against mildew.

Technical data sheet

Safety data sheet

Other product specific documents

Surface preparation

Clean new surfaces from dust and dirt. Wash previously painted surfaces with RENSA SUPER paint cleaner. Matt down hard or gloss surfaces by sanding and thereafter remove the dust. Brittle surfaces and untreated wooden surfaces must be primed before the filler is applied.

Application

Apply the filler by trowel. The number of layers is dependent on the surface roughness. The dried filler can be painted or wall-papered. Before wall-papering the filler surfaces must be primed with adhesive. The use of protective mask for eyes and face is recommended when grinding the filler.

Application conditions

The surface to be treated must be dry. The temperature of the air, the surface and the filler shall be above +5 °C and the relative humidity of the air below 80 % during the time of application and drying.

Storage

To be stored in a cool place. Must not freeze. Storage stability is 1 year in unopened package.
Solids abt. 61 % by volume
Volatile organic compound (VOC) The product is not included in the EU VOC directive.
Layer thickness 0 - 4 mm
Density abt. 1 g/ml
Particle size 0.2
Clean up Water
Packages 0,4 L, 3 L, 10 L
Safety markings See Safety Data Sheet.
Approvals & certificates CE marking