WOODEX EKO

NEW WOOD SURFACES: Remove from the surface all loose matter, dirt, dust and mildew. If needed, use RENSA FACADE facade cleaner. Prime log surfaces with a wood preservative from the WOODEX series before the actual treatment, and allow the surfaces to dry for one day. SURFACES PREVIOUSLY TREATED WITH WOOD STAIN: Clean from the surface all loose matter, dirt and dust. Remove loose and poorly adherent old wood stain and fluffy top layers of the wood by e.g. steel brush and steel scraper. Wash dirty and/or mildewed surfaces with RENSA FACADE facade cleaner. Rinse the surfaces thoroughly with water and allow to dry. Press-impregnated wood must be subjected to weathering for at least 6 months before it is treated with WOODEX EKO.

Stir the wood stain well before use. Before the actual application the wood stain should be tested on a small surface corresponding to the surface to be treated. The result of the application depends on the porosity and absorbency of the wood, the number of coats applied and the application method. Sawn and planed surfaces have a different appearance after one application, even if the stain is applied from the same can. Apply WOODEX EKO in one or two coats depending on the strength of the colour and the desired result. Treat end grain with special care. When old surfaces have a certain colour that you wish to preserve, mix clear WOODEX EKO with the colour in question. Stir thoroughly before use. It is not recommended that clear wood stain is used alone due to restricted weather resistance. Apply WOODEX EKO by brush or spray. Suitable nozzle for airless spray is 0.013 - 0.017".

The surface to be treated must be dry. The moisture of the wood must be below 20 % of the dry weight of the wood. During the application and drying period the temperature of the ambient air, the surface and the wood stain shall be above +5 °C and the relative air humidity below 80 %.

MUST NOT FREEZE.