ALPOCRYL KLARLACK 1495-95

Solvent-based 2C high-gloss coating for interior use

  • 2-component
  • Solvent-borne
  • Clear coat

ALPOCRYL KLARLACK 1495 is a solvent-based 2C high-gloss paint for top-class interiors. The coating is resistant to household chemicals and mechanical stress. ALPOCRYL KLARLACK 1495 can also be used for ship interiors. The products have an appealing surface with a good mechanical strength.

When used as a flame retardant coating for seagoing ships according to SOLAS (International Convention for the Safety of Life at Sea) 74/88 Reg. II-2/3, II-2/5 and II-2/6, latest version, IMO Resolution MSC.36(63)-(1994 HSC Code)7, IMO Resolution MSC.97(73)-(2000 HSC Code)7, this product can only be combined with other approved and technically suitable products. A risk assessment has been carried out according to Directive 2014/90/EU, Annex II, Section 3. The cured and dried coating poses neither a physical nor a health hazard, nor a hazard to the environment. When used in ship interiors, the maximum total product application quantity of 210 g/m2 should never be exceeded.

Surface preparation

Every substrate must be well-cleaned, dry and free from grease and oil. Coating removal: Sand, strip

Application

Stir or shake the product well for several minutes before use, if necessary by machine.

Application conditions

Recommended temperature for surroundings and product: +15°C-25°C. Do not apply below +10°C. Ideal relative humidity 50-60%.

Storage

Storage temperature is +5°C - +30°C. Store in a tightly closed container.

On MDF boards with a density of below 700 kg/m3 the surface must be pre-isolated with ALPOLAN UNIVERSALGRUND 2420-00. Strengthen the edges or milled grooves with ALPOLAN UNIVERSALGRUND 2420-00. Moisture-resistant wood based materials must be used for rooms with a high moisture exposure (e.g. kitchens, bathrooms etc.). This product should not be used on horizontal surfaces in these areas. Always filter the high-gloss coating through a 50 µm sieve before filling the spray gun. We recommend using a spray gun with a nozzle size of up to 1.4 mm. A uniform surface can be achieved by applying in cross layers. The gloss level of the surface is affected by the techniques used: Layer thickness, spraying technique and drying conditions. We recommend carrying out a spray test with the product before starting work. Important information: The recommendations in the data sheets "7 days – 7 steps" (VTM 4275) and "10 tips for high-gloss coating" (VTM 4120) must always be observed.
Weight solids abt. 49 % by weight
Volatile organic compound (VOC) abt. 503 g/l
Pot life 3-4 h (+23 °C)
Mixing ratio 2:1 by volume (comp. A : comp. B)
Hardener Comp. B: UNIPUR 279 1910-99
Theoretical spreading rate 150 g/m²; 6.6 m²/kg
Density abt. 0.99 g/ml
Drying time – dust free after 20 minutes
Drying time – touch dry after 6 hours
Drying time – through-dry after 10-14 days
Drying time - overcoatable after 16 hours
Thinner VERDÜNNER 0950-98, VERDÜNNER 1300-98.
Clean up Wash the equipment immediately after use.
Colours Colourless.
Safety markings See safety data sheet.
Approvals & certificates IMO FTPC Part 2,IMO FTPC Part 5,Marine Equipment Approval (Module B)
Gloss value 95