WOODFLOOR 6800-30
Solvent-based 2C PU floor sealing coating for interior use
- 2-component
- Solvent-borne
- Sealer
- 2-component
- Solvent-borne
- Sealer
WOODFLOOR 6800-30 is a solvent-based, ready-to-roll, highly abrasion-resistant 2C PU floor sealing coating for the treatment of wood parquet floors and stripped floor boards. The product has a higher mechanical and chemical resistance than water-borne sealing coatings. Abrasion and scratch resistance meet the requirements of floors exposed to normal wear in residential areas; depending on the degree of wear, use in commercial properties is also possible without any problems.
Technical data sheet
Surface preparation
Every substrate must be well-cleaned, dry and free from grease and oil. Coating removal: Sand
Application
Stir or shake the product well for several minutes before use, if necessary by machine.
Application conditions
Recommended temperature for surroundings and product: +15°C-25°C. Do not apply below +10°C. Ideal surface and object temperature for application: +18°C-22°C. Avoid application in direct sunlight. Underfloor heating systems must be adjusted well in advance.
Maintenance
Initial and maintenance care: After at least 3 weeks curing time with RENSA FLOOR POLISH 4580.
Storage
Storage temperature is +5°C - +30°C. Store in a tightly closed container.
Polyurethane coatings may tend to stick to the sides, especially on upright slats, non-shear bonded strip and mosaic parquet floors, on underfloor heating etc. For these reasons the use of a primer is recommended.
We recommend direct application in 2-3 coats for objects subject to special stresses and substrates with a low absorbency. Dilute the first coat with 10% VERDÜNNER 5500-98.
| Weight solids | abt. 36 % by weight |
|---|---|
| Volatile organic compound (VOC) | abt. 633 g/l |
| Pot life | 16 h (+23 °C) |
| Mixing ratio | 5:1 by volume (comp. A : comp. B) |
| Hardener | Mix in hardener mechanically for several minutes. Comp. B: UNIPUR 279 1910-99 |
| Theoretical spreading rate | 150 g/m²; 6.6 m²/kg |
| Density | abt. 1 g/ml |
| Drying time – dust free | after 1-2 hours |
| Drying time – through-dry | after 7 days |
| Drying time - overcoatable | after 8 hours |
| Clean up | Wash the equipment immediately after use. VERDÜNNER 1000-98, VERDÜNNER 1300-98, VERDÜNNER 5500-98. |
| Colours | Colourless. |
| Safety markings | See safety data sheet. Do not smoke during the application and keep away from ignition sources. |
| Gloss value | 30 |