TEKNOHEAT 1176
Silicone coat
- Corrosion protective
- Heat resistant
- 1-component
- Solvent-borne
- Single coat paint
- Corrosion protective
- Heat resistant
- 1-component
- Solvent-borne
- Single coat paint
TEKNOHEAT 1176 is a one-component, solvent-borne silicone paint based on a modified combination of silicone resins.
It provides high corrosion protection and fast physical drying, and is suitable for applications requiring high-temperature resistance. The coating offers short-term thermal resistance up to 450 °C and permanent resistance up to 300 °C.
Technical data sheet
Surface preparation
Remove from the surfaces any contaminants that might be detrimental to surface preparation and application. Remove also water-soluble salts by using appropriate methods. The surfaces are prepared according to the different materials as follows:
STEEL SURFACES: Remove mill scale and rust by blast cleaning to preparation grade Sa 2½ (standard ISO 8501-1). Roughening the surface of thin-plate improves the adhesion of the paint to the substrate.
The place and time of the preparation are to be chosen so that the prepared surface will not get dirty or damp before the subsequent treatment.
Additional instructive information for surface preparation can be found in standards EN ISO 12944-4 and ISO 8501-2.
Application
Stir thoroughly before use.
Suitable airless nozzle size 0.011 - 0.013".
Application conditions
The surface to be treated must be dry. During the application and drying period the temperature of the ambient air, the surface and the product shall be above +10°C and the relative air humidity below 80%. Additionally, the temperature of the surface to be treated and the product must be at least +3°C above the dew point of the ambient air.
Storage
The storage stability is shown on the label. Store in a cool place and in tightly closed containers.
| Solids | abt. 32 % by volume |
|---|---|
| Weight solids | abt. 53 % by weight |
| Volatile organic compound (VOC) | abt. 619 g/l |
| Gloss | Matt |
| Density | abt. 1.31 g/ml |
| Practical spreading rate | The values depend on the application technique, surface conditions, overspray, etc. |
| Drying time – forced drying | 1 h at 200°C 30 min at 250°C |
| Thinner | TEKNOSOLV 6740 |
| Clean up | TEKNOSOLV 6740 |
| Colours | Black. |
| Safety markings | See safety data sheet. |