TEKNOBLADE REPAIR 9000-20
Elastomeric coating
TEKNOBLADE REPAIR 9000-20 is a two-pack, solvent-free elastomeric coating designed for dispenser gun application. Intended for use as a repair product for refurbishment of Leading Edge Protection on Wind Turbine Blades. Substrate types: Tested and approved on Fibre reinforced polymer and previously lacquered surface.
Intended for use as a repair product for refurbishment of Leading Edge Protection on Wind Turbine Blades.
TEKNOBLADE REPAIR 9000-20 withstands impacts and hard abrasion. It will cure down to a temperature of -8 °C. The coating will yellow and chalk over time when exposed to UV light. However, the coating will still maintain protection against rain erosion despite the discoloration. TEKNOBLADE REPAIR 9000-20 is usually applied in 2-3 mm thickness.
Technical data sheet
Safety data sheet
Other product specific documents
Surface preparation
Application
Application conditions
Storage
| Solids | abt. 100 % by volume |
|---|---|
| Total mass of solids | abt. 1080 g/l |
| Volatile organic compound (VOC) | abt. 0 g/l |
| Pot life | 120 sec. (+23 °C) |
| Mixing ratio | 1:1 by volume (comp. A : comp. B) |
| Hardener | Comp. B: TEKNOBLADE REPAIR HARDENER 7000 |
| Gloss | Gloss |
| Practical spreading rate | The values depend on the application technique, surface conditions, overspray, etc. To obtain sufficient rain erosion protection – a film thickness below 1.5 mm is not recommended. |
| Drying time – dust free | Approx. 6 min. |
| Drying time – fully cured | Approx. 1 day |
| Colours | White. |
| Safety markings | See safety data sheet. |