HOLZSTAUBBINDEMITTEL 0440-00
Water-borne wood dust binder for the production of fillers for interior use
- Water-borne
- Dust binder
- Water-borne
- Dust binder
HOLZSTAUBBINDEMITTEL 0440-00 is a water-borne, viscoplastic wood dust binder (joint filler solution) for the production of fillers and "liquid wood". The product is characterised by its fast-drying properties and good sandability.
Technical data sheet
Safety data sheet
- HOLZSTAUBBINDEMITTEL 0440-00_2021-06-28_CN_en
- HOLZSTAUBBINDEMITTEL 0440-00_2021-06-28_FI_en
- HOLZSTAUBBINDEMITTEL 0440-00_2023-09-07_GB_en
- HOLZSTAUBBINDEMITTEL 0440-00_2024-05-17_EU_en
- HOLZSTAUBBINDEMITTEL 0440-00_2024-05-17_IE_en
- HOLZSTAUBBINDEMITTEL 0440-00_2024-05-17_MT_en
- HOLZSTAUBBINDEMITTEL 0440-00_2024-05-17_NI_en
Surface preparation
Every substrate must be well-cleaned, dry and free from grease and oil. Coating removal: Sand
Application
Stir or shake the product well for several minutes before use, if necessary by machine.
Application conditions
Recommended temperature for surroundings and product: +15°C-25°C. Do not apply below +10°C. Ideal surface and object temperature for application: +18°C-22°C. Avoid application in direct sunlight. Underfloor heating systems must be adjusted well in advance.
Maintenance
For further information on products for treating the surfaces of wooden floors and their use please visit www.parkett-verband.ch.
Storage
Storage temperature is +5°C - +30°C. Store in a tightly closed container.
Only use up to a maximum joint width of 2 mm.
Put the HOLZSTAUBBINDEMITTEL 0440 in a container, stir in the wood sanding dust with a spatula. Depending on the desired consistency, add wood dust or HOLZSTAUBBINDEMITTEL 0440.
Mixing ratio: Mix 15-20 g of wood dust with 100 g of the wood dust binder.
Required quantity: 40-50 g of the wood dust mixture is sufficient for an area of approx. 1 m². The required quantity can vary significantly depending on the type and extent of joints and dents.
Trowel-fill, sand. Can subsequently be reworked with all parquet floor primers and/or all water-soluble parquet coating systems, oils as well as all solvent-based parquet floor sealing coatings.
Does not cause discolouration on the wood.
| Weight solids | abt. 12 % by weight |
|---|---|
| Volatile organic compound (VOC) | abt. 50 g/l |
| Density | abt. 1.01 g/ml |
| Drying time – dust free | after 60 minutes |
| Drying time - overcoatable | after 1-2 hours |
| Clean up | Wash the equipment immediately after use. VERDÜNNER 1000-98 |
| Colours | Colourless. |
| Safety markings | See safety data sheet. |
| Approvals & certificates | EMICODE EC 2,Swiss environmental label UE II, class B |