HELO 15
Matt special varnish
- Wear resistant
- Solvent-borne
- Varnish
- Wear resistant
- Solvent-borne
- Varnish
HELO 15 is a fast drying urethane/alkyd based varnish with good resistance properties. The varnish is suitable for varnishing all demanding woodwork indoors and outdoors. Finish: matt.
Examples of uses are wooden plank floors, furniture and other wooden surfaces whenever a durable varnish coat is desired.
HELO 15 produces a varnish film which is hard and at the same time elastic and thus withstands abrasion and impacts. Detergents, grease or oil do not damage it.
Technical data sheet
Safety data sheet
Product colour chart
Surface preparation
Clean the surfaces from grease and dirt. Wash varnished surfaces with RENSA SUPER paint cleaner. Matt down old, intact varnish coats. If the old varnish coat is brittle or flaking, it is removed by scraper and paint remover. Cautious burning off can also be used. Thereafter the surface is sanded and sanding dust is carefully removed. Objects that are intended for outdoor use are before the varnishing primed with clear wood preservative from the WOODEX series. Sand the surface again before varnishing and remove the dust.
Application
Before use stir the varnish thoroughly down to the bottom of the can. Use always full gloss HELO 90 for priming and thin it by adding about 20% TEKNOSOLV 1621. Sand lightly and remove the dust before the top coating. Top coat with undiluted HELO 15 by applying 1 - 3 coats. Sand lightly and remove the dust between all varnish coats. Apply the varnish with a broad varnish brush. There must be good ventilation during the application and the drying period of the varnish. Note! For outdoor use we recommend tinted varnish.
Application conditions
The surface to be varnished has to be dry. During the varnishing and drying period the temperature of the ambient air, the surface and the varnish shall be above +10 °C and the relative air humidity below 80 %.
Maintenance
The varnished surface reaches its final hardness and washability within 3 - 4 weeks. Rough handling and washing is to be avoided during this period. Stained surfaces can be cleaned with a moist cleaning cloth or mop. Use a neutral detergent. Very dirty surfaces can later be cleaned with a slightly alkaline universal washing detergent.
Storage
Must be stored tightly closed and kept cool.
| Solids | abt. 41 % by volume |
|---|---|
| Volatile organic compound (VOC) | EU VOC limit value (kat A/i): 500 g/l. The product's VOC: max. 500 g/l. |
| Gloss | Matt |
| Tinting system | Teknomix |
| Density | abt. 0.9 g/ml |
| Practical spreading rate | 10 - 14 m²/l |
| Drying time – dust free | after 1 hour |
| Drying time – touch dry | after 6 hours |
| Drying time - overcoatable | after 16 hours |
| Thinner | TEKNOSOLV 1621 (solvent naphtha) |
| Clean up | TEKNOSOLV 1621 (solvent naphtha) |
| Colours | Clear. The varnish is included in the Teknomix tinting system (transparent colours). |
| Packages | 0,45 L, 0,9 L, 2,7 L, 9 L |
| Safety markings | See Safety Data Sheet. NOTE! Because of the danger of self-ignition, any waste from the product, spray mist and soiled rags etc. are to be kept in a fire-proof place in air-tight containers. Immersion in water is also recommended. |
| Approvals & certificates | Finnish Key Flag |