INFRALIT EP/PE 8235-30
Epoxy/polyester powder
- Antimicrobial / Disinfectant
- Powder coating
- Antimicrobial / Disinfectant
- Powder coating
INFRALIT EP/PE 8235-30 is a powder coating based on a mixture of solid epoxy and polyester binders. At elevated temperature the powder will melt, cure and form the final paint film.
INFRALIT EP/PE 8235-30 is suitable for coating objects where high hygiene management is needed. INFRALIT EP/PE 8235-30 contains BioCote® silver phosphate glass antimicrobial technology to preserve the coating surface and prevent colonisation and degradation caused by microbial growth on the paint film once applied to the intended substrate. It’s recommended as coating solution for hygiene management of public spaces, such as hospitals, schools, offices and meeting rooms. INFRALIT EP/PE 8235-30 forms a film with mechanical and chemical resistance and good anticorrosive properties. On outdoor exposure INFRALIT EP/PE 8235-30 epoxy/polyester powder has a tendency towards matting down (chalking) similar to that of pure epoxies. On the other hand, its tendency to yellow on overbaking and exposure to heat and ultraviolet light is minor as compared with epoxy powders.
Technical data sheet
Safety data sheet
Other product specific documents
Surface preparation
Storage
| Gloss | Matt |
|---|---|
| Practical spreading rate | 4 - 15 m²/kg depending on the film thickness. |
| Spraying | TRIBO/CORONA |
| Curing time | 10 min/200°C (metal temperature) |
| Colours | By agreement. |
| Packages | 20 kg. |
| Safety markings | See safety data sheet. The powder itself is non-flammable, but with air it can form an explosive mixture that in presence of adequate ignition energy ignites. The lower explosion limit of typical powder coatings is between 20 g/m³ and 80 g/m³ (CEPE, Safe Powder Coating Guideline 8th Edition, 2020). Ventilation of the spray booth should be adjusted so that the concentration of powder in the air is less than 50% of the lower explosive limit value. On calculation of the powder concentration in the spray booth, the powder deposited on the workpiece is not taken into account. In order to avoid the discharge of powder from the booth into adjacent working spaces, the speed of air flow in the apertures of the booth must not fall below 0.5 m/s. Spray painters should wear dust masks and protective gloves. Any spatter of powder on the skin should be washed off with water and soap. |
| Gloss value | 20-40 |