HOLZSTAUBBINDEMITTEL 0340-00
Alcohol-based wood dust binder for the production of fillers for interior use
- Solvent-borne
- Dust binder
- Solvent-borne
- Dust binder
HOLZSTAUBBINDEMITTEL 0340-00 is a viscoplastic wood dust binder (joint filler solution) with a mild odour for the production of fillers and "liquid wood". The product is characterised by its very fast-drying properties and good sandability.
Surface preparation
Every substrate must be well-cleaned, dry and free from grease and oil. Coating removal: Sand
Application
Stir or shake the product well for several minutes before use, if necessary by machine.
Application conditions
Recommended temperature for surroundings and product: +15°C-25°C. Do not apply below +10°C. Ideal surface and object temperature for application: +18°C-22°C. Avoid application in direct sunlight. Underfloor heating systems must be adjusted well in advance.
Maintenance
For more information on wood floor surface treatments and their use, visit www.parkett-verband.ch.
Storage
Storage temperature is +5°C - +30°C. Store in a tightly closed container.
Only use up to a maximum joint width of 2 mm.
Put the HOLZSTAUBBINDEMITTEL 0340 in a container, stir in the wood sanding dust with a spatula. Depending on the desired consistency, add wood dust or HOLZSTAUBBINDEMITTEL 0340.
Mixing ratio: Mix 15-20 g of wood dust with 100 g of the wood dust binder.
Required quantity: 40-50 g of the wood dust mixture is sufficient for an area of approx. 1 m². The required quantity can vary significantly depending on the type and extent of joints and dents.
Trowel-fill, sand. Can subsequently be reworked with all parquet floor primers and/or all water-soluble parquet coating systems, oils as well as all solvent-based parquet floor sealing coatings.
Does not cause discolouration on the wood.
| Density | abt. 0.85 g/ml |
|---|---|
| Drying time – dust free | 20 min |
| Clean up | Wash the equipment immediately after use. VERDÜNNER 1000-98 or POLITURSPRIT 4100-98. |
| Colours | Colourless. |
| Safety markings | See safety data sheet. Do not smoke during the application and keep away from ignition sources. |
| Approvals & certificates | Swiss environmental label UE II, class F |