• Heat resistant
  • Special adhesion

Matt, acrylate-based dispersion paint.

Walls and ceilings in interior spaces. Radiators and heating pipes, galvanized air ducts and cast concrete surfaces. The surface can be chip, fibre, gypsum or any interior board, wood, concrete, thin-plate, plaster, brick and stopper. Adheres also well onto clean oil and alkyd paint surfaces and onto plastic coated thin-plate.

SUPERLATEKSI has excellent adhesion, levelling and washability. Resists momentarily 125°C temperature without yellowing.

Surface preparation

The surface to be painted must be clean. Clean new surfaces from dust and dirt. Wash previously painted surfaces with RENSA SUPER paint cleaner. Remove loose and poorly adherent paint coats. Matt down hard or gloss surfaces by sanding and thereafter remove the dust. For smoothing of irregularities in the surface choose a suitable stopper from the SILORA series. The dried stopper is sanded down and the dust removed.


To prevent the knots bleeding on wood the surfaces are primed with FUTURA 3 Adhesion primer. Steel surfaces are primed with FERREX AQUA Anticorrosive paint. Prime other surfaces directly with SUPERLATEKSI. Before use stir the paint thoroughly. The paint is thinned with water when needed. Reserve a sufficient amount of paint in the same vessel for each uniform surface. Colour differences will thus be avoided. Apply once or twice by brush, roller or spray.

Application conditions

The surface to be painted must be dry. During the application and drying period the temperature of the ambient air, the surface and the paint shall be above +5 °C and the relative air humidity below 80 %. Good ventilation during the application and drying period quickens the drying process.


The final forming of the paint film takes abt. 4 weeks under normal circumstances and after that the ultimate durability and hardness is reached. Before this the painted surface must be treated with care. The painted surface can be cleaned by wiping with a neutral (pH 6 - 8) detergent. For very dirty surfaces can also alkalescent (pH 8 - 10) detergents be used. Detergent and dirt are removed by wiping and/or rinsing the surface with clean water. Use a cleaning cloth, soft sponge or similar for cleaning. Avoid coarse brushing or heavy abrasion. Follow the dilution and other instructions of the detergent producer when using detergents.


Must not freeze.
Solids abt. 41 % by volume
Volatile organic compound (VOC) EU VOC limit value (kat A/a): 30 g/l. The product´s VOC: max. 30 g/l.
Gloss Matt
Tinting system Teknomix
Density abt. 1.4 g/ml
Drying time – dust free after ½ hour
Thinner Water.
Clean up Wash the equipment immediately after use with detergent and warm water.
Washability and wear resistance Wear resistance of the painted surface is very good. The painted surface can be washed. Wet scrub resistance, class 1 according to EN 13300 (ISO 11998).
Packages Base paint 1: 0,9 L, 2,7 L, 9 L, 18 L. Base paint 3: 0,9 L, 2,7 L, 9 L
Safety markings See Safety Data Sheet.
Approvals & certificates Finnish Key Flag