TEKNOFLOOR 100F
Concrete paint and varnish
- 2-component
- Solvent-borne
- Primer
- Topcoat
- 2-component
- Solvent-borne
- Primer
- Topcoat
TEKNOFLOOR 100F is a two-pack epoxy paint for concrete floors.
Used for concrete floors whenever an abrasion-resistant paint coat is required. When good colour and gloss retention is required TEKNOFLOOR 100F can be overcoated with TEKNODUR 0100 -series polyurethane top coats. The product has CE approval for protection of concrete structures.
Technical data sheet
Safety data sheet
Other product specific documents
Surface preparation
NEW CONCRETE SURFACES: The concrete must be at least 4 weeks old and well-hardened so that all moisture from casting is bound and the surface dry. The moisture of the concrete must not exceed 97% as relative humidity or 4% by weight (by 54 / BLY 12).
Dense laitance is to be removed from steel-trowelled concrete by shot-blasting or surface grinding. Brittle and powdery top layers are treated so that the solid concrete containing aggregate is exposed. Thereafter all cement dust is removed by vacuum cleaner or brush. The concrete surface must be clean of anything that might hinder the adhesion.
Surface grinding is good method to remove laitance. It is usually done on new industrial floors as wet grinding in connection with casting.
Application
Application conditions
The surface to be treated must be dry. During the application and drying period the temperature of the ambient air, the surface and the product shall be above +10°C and the relative air humidity below 80%. Additionally, the temperature of the surface to be treated and the product must be at least +3°C above the dew point of the ambient air.
Storage
The storage stability is shown on the label. Store in a cool place and in tightly closed containers.
| Volatile organic compound (VOC) | paint: approx. 480 g/l varnish: approx. 560 g/l |
|---|---|
| Pot life | 6 h (+23 °C) |
| Mixing ratio | 3:1 by volume (comp. A : comp. B) |
| Hardener | Comp. B: TEKNOFLOOR HARDENER 100H |
| Gloss | Gloss |
| Tinting system | Teknomix |
| Practical spreading rate | Depending on the surface strength of the concrete. The recommended values for surface-ground hard and vacuum concrete floors: First application with 40 % diluted paint 5 - 7 m²/l Second application with undiluted paint 6 - 9 m²/l The recommended values for handmade floors: First application with 30% diluted paint 3 - 5 m²/l Second application with undiluted paint 5 - 7 m²/l |
| Drying time – fit for light traffic | 12 h |
| Thinner | TEKNOSOLV 9506 |
| Clean up | TEKNOSOLV 9506 |
| Colours | |
| Safety markings | See safety data sheet. |
| Approvals & certificates | CE marking |