EMAPUR MARINA

Polyurethane enamel

  • UV resistant
  • Water resistant
  • Enamel
  • 2-component
  • Solvent-borne

Polyurethane, two component enamel. The hardener is an aliphatic isocyanate resin.

For final painting of areas of yachts and ships above the waterline.

High decorative, gloss coating, good adhesive to substrate, tough and flexible. Resistant to weathering, sun radiation, sanitary, fresh and sea water, salt and alkali solutions, thinned acid solutions, oil, fuel oil, diesel and some thinners (gasoline, xylene). Coating in white colors shows a reflectivity of solar radiation above 70%.

Technical data sheet

Surface preparation

Coating of epoxy primer BOSMAN dry, salt-, dust- and grease-free. Then it is recommended to wash all surface with water with addition of OLIVA CLEANER, and next rinse with clean water.

Application

Airless spray, brush, roller, after diluting – air spray. Airless spray parameter - nozzle size: 0,33 - 0,43 mm, nozzle pressure: 10 - 15 MPa.

Application conditions

Minimum surface temperature: -5°C (surface frost- and ice-free) and at least 3 °C higher than dew point, relative air humidity below 80%, good ventilation
Solids abt. 56 % by volume
Volatile organic compound (VOC) abt. 420 g/l
Pot life 2 h (+23 °C)
Mixing ratio 100:22 by volume (comp. A : comp. B)
Hardener Comp. B: EMAPUR MARINA UTWARDZACZ
Gloss Gloss
Tinting system Teknotint
Recommended film thickness Dry film (µm) 50. Wet film (µm) 90.
Drying time – dust free after 3 h
Drying time – touch dry after 8 h
Thinner Not recommended. When necessary (for example – thickening product) use TEKNOSOLV 433.
Clean up TEKNOSOLV 433
Packages Base: 0,6 l Hardener: 0,14 l
Safety markings See Safety Data Sheet