BOSMAN 1

Epoxy filler

  • Water resistant

Two component, 100% solids thixotropic epoxy filler.

For repairing of ceramic, cast iron and steel surfaces and also epoxy- and glass-polyester laminates.

Can be applied up to 4 mm. Fully cured coating is water resistant.

Technical data sheet

Surface preparation

Epoxy or polyester laminates roughened with abrasive paper and dust-free surface. Steel or cast iron surfaces primed with ALU STEEL PRIMER 2002 diluted 20-30% with 564 Thinner. Dry, rust-, grease- and dust-free surface. Ceramic surfaces primed with WOOD PRIMER 12 diluted 20% with Thinner 564. Dry, rust-, grease- and dust-free free surface.

Application

Steel trowel, putty knife or spatula. After cure it is recommended to wet or dry polish with 80-200 abrasive paper.

Application conditions

Minimum surface temperature: +10°C and at least 3°C higher than dew point, relative air humidity below 80%, good ventilation.
Solids abt. 100 % by volume
Volatile organic compound (VOC) abt. 8 g/l
Pot life 1 h (+23 °C)
Mixing ratio 1:1 by volume (comp. A : comp. B)
Hardener Comp. B: BOSMAN 1 UTWARDZACZ
Recommended film thickness Dry film (µm) 500. Wet film (µm) 500.
Drying time – dust free after 8 h
Drying time – touch dry after 14 h
Thinner Not recommended
Clean up TEKNOSOLV 564
Packages 2 x 0,25 l
Safety markings See Safety Data Sheet