TEKNOPLAST PRIMER 3

Epoxy primer

  • Chemical resistant
  • Wear resistant
  • Intermediate
  • 2-component
  • Primer
  • Solvent-borne

TEKNOPLAST PRIMER 3 is a two-pack solvent-borne epoxy primer.

Used as primer in abrasion and chemical resistant Coating Systems K18 and K53 on blast-cleaned steel. Can also be used for priming on zinc, aluminium, thin-plate, acid-proof steel and cast iron surfaces. Used as an intermediate coat over zinc epoxy and zinc silicate primers in Coating Systems K19 and K22.

The paint is quickly overcoatable and is therefore suited to a fast painting tempo. It is also suitable for application by twin-feed spray. The paint withstands heavy abrasion, oils, grease, solvents and chemicals. Either TEKNOPLAST PRIMER WINTER HARDENER 7399 (data sheet no. 1320) or TEKNOPLAST WINTER HARDENER 7212 (data sheet no. 1317) is to be used when painting at temperatures below +10°C .

Solids abt. 53 % by volume
Total mass of solids abt. 910 g/l
Volatile organic compound (VOC) abt. 440 g/l
Pot life 4 h (+23 °C)
Mixing ratio 4:1 by volume (comp. A : comp. B)
Hardener Comp. B: TEKNOPLAST HARDENER
Gloss Semi-matt
Drying time – dust free after 1 h
Drying time – touch dry after 4 h
Thinner Standard thinner: TEKNOSOLV 9506
Clean up TEKNOSOLV 9506 or TEKNOSOLV 9530