TEKNOMASTIC 80 PRIMER

Epoxy primer

  • Chemical resistant
  • Wear resistant
  • Intermediate
  • 2-component
  • Primer
  • Solvent-borne

TEKNOMASTIC 80 PRIMER is a two-pack solvent-borne epoxy primer with low solvent content.

Used as a priming coat or as a single coat in abrasion and chemical resistant epoxy coating systems on blast-cleaned steel. Can also be used for priming zinc, aluminium, thin-plate and acid-proof steel surfaces and as an intermediate coat over zinc epoxy and zinc silicate primers.

The paint is quickly overcoatable and is therefore suited to a fast painting tempo. The paint film withstands heavy abrasion, oils, grease, solvents and chemical splashing. The paint is suitable for maintenance painting of steel surfaces which are cleaned at least to preparation grade St 2. The paint comes up to the requirements of standard NORSOK M-501:2012 (Edition 6) systems 1, 7A and 7B (Certificates 11-17-14/1, 11-17-14/2 and 6-9-15/1). For the product there is also available a WINTER hardener TEKNOMASTIC WINTER HARDENER 7275, which is used when the painting is done in temperatures below +10°C. When using the WINTER hardener it will strengthen the yellowing and chalking that is typical for epoxy paints. White and light shades (e.g. RAL-9001, RAL-9003, RAL-9010 and RAL-9016) are especially susceptible for yellowing.

Solids abt. 82 % by volume
Total mass of solids abt. 1300 g/l
Volatile organic compound (VOC) abt. 200 g/l
Pot life 2 h (+23 °C)
Mixing ratio 4:1 by volume (comp. A : comp. B)
Hardener Comp. B: TEKNOMASTIC HARDENER 7465
Gloss Semigloss
Drying time – dust free after 2 h
Drying time – touch dry after 6 h
Drying time – fully cured after 7 d
Thinner TEKNOSOLV 9506
Clean up TEKNOSOLV 9506 or TEKNOSOLV 9530
Approvals & certificates NORSOK M-501