HELO AQUA 40
Semigloss water-borne special varnish
- Wear resistant
HELO AQUA 40 is a semigloss water-borne special varnish based on polyurethane dispersion. For wooden surfaces indoors and outdoors.
Wooden plank floors and parquet floors as well as stairs indoors, wooden furniture indoors and outdoors.
Technical data sheet
Safety data sheet
Other product specific documents
The wooden surface must be dry, carefully sanded and cleaned from dust and other impurities. Stir HELO AQUA 40 well both before use and between the applications, but be careful not to let air into the varnish.
Untreated parquets and wooden plank floors: Prime with 15 % diluted HELO AQUA 80 using brush, trowel or roller. Finish with 2 - 3 coats of HELO AQUA 40 using brush or trowel. Spread out the varnish in the direction of the pattern and the grain of the wood. Previously varnished floors: It is recommended that the surfaces are sanded to bare wood and that the instructions above for untreated parquet and wooden plank floors are followed. If the old varnished coat is in good condition HELO AQUA 40 varnish can be applied according to the instructions for finishing to a surface that has been carefully sanded (sanding paper no. 150 or finer). In this case, however, the varnish is first to be tested on a small area to ensure proper adhesion. Stairs and furniture: Brush application is recommended for stairs and furniture. Prime with HELO AQUA 80, if needed. Apply first a thin coat of HELO AQUA 40 varnish and let it dry for at least one hour. Sand the surface and remove all sanding dust carefully. Apply a second coat of varnish and let dry for about 3 hours before applying the third coat. Note! For objects outdoors we recommend tinted varnish and avoiding use on horizontal surfaces.
During the varnishing and drying period the temperature of the ambient air, the surface and the varnish shall be above +10 °C and the relative air humidity below 80 %.
The varnish reaches its final hardness within 1 - 2 weeks. Hard abrasion is thus to be avoided during 2 weeks after the treatment.
Must not freeze.
|Solids||abt. 32 % by volume|
|Volatile organic compound (VOC)||EU VOC limit value (kat A/i): 140 g/l. The product's VOC: max. 140 g/l.|
|Drying time – dust free||after 1 - 3 hours.|
|Drying time – dry to use||The surfaces can be taken into use 24 hours after application of the last coat.|
|Clean up||Wash the equipment immediately after use with detergent and water.|
|Packages||0,45 L, 0,9 L, 2,7 L, 9 L|
|Safety markings||See Safety Data Sheet.|
|Approvals & certificates||M1 classification|